I have a spa motor that needs to be re-built. It humms but does not turn even though the shaft will spin manually. It is a;
MagneTek Flex-48 Pool/Spa Motor
1563/1081 Pump Duty
Cat: BN37 Part: 8-177782-01 FR: R48Y Type:CSM
HP: 1.0-1.2 RPM: 3450/1725 Hz: 60
Volts: 115 Amps: 11.0/2.9
Could you please tell me if this is something you do, what the cost would be, and how to proceed with the hot tub pump.



HI A FRIEND OF MINE IS GIVING ME HIS HOT TUB . THE TUB IS FINE BUT THE SPA PACK IS IN BAD SHAPE. I WOULD LIKE TO KNOW IF YOU COULD EITHER DIRECT ME TO A SERVICE CENTER OR GIVE ME A PRICE FOR A REPLACEMENT SPA PACK. THE ONE THAT IS IN THE HOT TUB IS A POLYNESIAN AND THE MODEL # IS 1.5K IT HAS A HAYWARD PUMP MODEL#S48K2A1O AND A HAYWARD STAY CLEAR FILTER MODEL #B16C . THE BLOWER IS A SANTANA MINI BLOWER #5239



Does the pump motor advertised on your web site as a Hayward 1 HP replacement motor fit a Hayward Super Pump II I need a HAYWARD SUPER PUMP motor ..model # C48J2N131.....I need this pump now .......this pump in good condition for our pool



have sundance hot tub with pumps model number SP 1520X15H3LS and SP1525X2H3LS I bought rebuild kits do to seal is leaking from around shaft. Could you send me hot tub pumps directions on how to get the pump off of the shaft and apart, and back into the tub. thanks


© PHONE FOR HELP 724-863-8006 Pumpwarehouse.com©

am putting in a 15 by 30 ft pool .and a 5ft round spa. the pool equipment will be about 10
ft from the Spa & Pool . I want to buy Purex equiptment becouse I was told that it is the best on the market now for the price ???. I also want to install the Salt system insted of cloring. I was told the heater should be 400 btu or higher ???. I was told the Jacuzzi should have 2hp motor for 6 jets would be enough ??? I like powerful jets. The filter I wanted the largest and so I was told to go with a 72 ???



© PHONE FOR HELP 724-863-8006 Pumpwarehouse.com©

I need the price on a 1 HP inground pool pump . What is the reliablity of Preimier pumps? Is Hayward better/more reliable? What else is there to choose from that is cost friendly and durable



© PHONE FOR HELP 724-863-8006 Pumpwarehouse.com©
I am looking for a seal kit for a hot tub pump . The numbers off the pump are: Magnetek, Century Lasar Pool / Spa Motor 1081/1563 Pump Duty , Catalog No. BN34. Part 7-177783-82 230 Volt 8.0/2.6 amp 1.5 hp - .18 SF 1.00 Magnetek 185242-05.


What is your price (shipping included) of an American Products pump motor
© PHONE FOR HELP 724-863-8006 Pumpwarehouse.com©
with the following specs:
1 hp... FR R56Y... Type CX... PH 1... SF 1.00 HZ 60
Model # of motor is 384694



i have an old jacuzzi pump model 5EP-S with a Gould "Century" 1 speed 1/2 hp Motor. the pump has served very well for over 14yrs. this is used as the circulating pump on a kidney shaped 750 gal spa. can you recommend a replacement pump or are there parts available or is it better to rebuild it. the motor is in good shape.



© PHONE FOR HELP 724-863-8006 Pumpwarehouse.com©
I am looking for a 4 1/2 hp spa pump. The one that I currently have is a 3 hp magnetek.Here are the specs; Magnetek century,pool motor-spa duty volts; 230 rpm; 3450/1725 part #; 8-193108-1 It has 1 1/2 inlet and outlet male thread. I need motor and pump housing. I would like to have one just like the one I have now except 4.5 hp. This is for a hot tub.


I need a "wet-end"? for my morgan spa. The motor is good. It is a Magnatek 1.5hp that also says Century pool & spa motor 1081 pool pump duty. Ineed an inpeller and bearing?seal kit, or housing and all . aqua flow backpump housing #9277068 front #91231401 impeller #91693651



I am looking for a replacement pump... OLD Motor and Pump
ITT Marlow... Model R125-C... Spec No. 0069C00C... 120 volts 10.5 amps PH 1... 50/60 hz...
This unit came with a swirl away Hydromassage bathtub pump.



© PHONE FOR HELP 724-863-8006 Pumpwarehouse.com©
I need a pump for my hot tub . The 1 1/8 HP motor is ok. The tub is purchased in 1988. It's a franklin electric model 4105030400, date code C88. Where I can purchase a replacement pump only apump for a hot for tub


WE HAVE GOT A GOULD CENTURY 108 POOL PUMP DUTY
THE IMPELLER HAS WORN AWAY CAN YOU GET A REPLACEMENT POOL PUMPFOR THIS. BELOW IS THE INFORMATION ON THE POOL PUMP. PART: 8-151777-01 ... FRAME: N56C ... TYPE: SC ... H.P: 3.0
CODE: F ... HERTZ: 60 ... PH: 3 ... ENCL: DP
AMPS: 9.0-8.6/4.3 ... SF: 1.15 ... FORM: KJC ... TIME: CONT
AMBEINT: 40oC ... SFA: 9.2/4.6 ... CAT NO. H740 ... SERIAL: Y2
ALSO ON THE POOL PUMP WAS A LABEL SAYING PREMIER PUMP & POOL PRODUCTS . INC. MODEL NO. 683B.30 SERIAL NO. 004281C



© PHONE FOR HELP 724-863-8006 Pumpwarehouse.com©